Author Topic: Removing a shaft Coupling  (Read 4579 times)

0 Members and 1 Guest are viewing this topic.

Offline RonT

  • Administrator
  • Hero Member
  • *****
  • Posts: 1202
    • RonTanis
  • Boat Make/Model/Year: American Skier/Eagle V-25/2001
Removing a shaft Coupling
« on: March 24, 2017, 08:02:35 AM »
Direct Drive shafts are pretty straight forward and can be removed in most cases without special tools.
1) remove the 4 bolts holding coupling to trans coupling
2) remove set screws if used, and or coupling nut inside coupling if it is a tapered shaft end (most since mid 80's)
3) saturate with penetrating oil, place a deep well socket as a spacer between the two couplings, and using  4 temp. longer bolts re-attach the couplings keeping the spacer centered between the output shaft & propshaft. Slowly tighten each bolt until the shaft moves out.

In my shop I use a special puller which is available in the parts store :https://www.skiboatpartsonline.com/index.php?route=product/product&path=25_114&product_id=425

V-Drive boats have a much more difficult scenario due to the compact nature, some are buried under the engine, and newer boats have the "pass through" transmission with the shaft & coupling easily visible behind the trans, but impossible to remove without a special puller. For these I recommend viewing my YouTube video:  https://www.youtube.com/watch?v=qjvc7gPfWzA&t=11s